Adding a User to a Data Feed

Access Level

When adding a User to a data feed, an access level will need to be designated.

Adding a User to a Data Feed

For new users

After configuring the data feed, the next step is to add users to the new data feed. This step can also be performed later in the Data Feeds page.

1. Click on Add users now

1. Select the access level, then select the users
2. Click Done to complete

1. Click on Complete feed configuration to finish the user setup
2. Then, click on Finish on the Configure feeds

   

1. This will add the new feed on the Data feeds list

Adding more Users

1. In the Data feeds page, click on the Feed name
2. Select the Users tab
3. Click on Add user

1. Set the access level and select the users
2. Then, click on Done to complete

If there are no more users to allocate, it will display the following below with "All users added" message

If no Users have been added to the data feed yet, the Add user button will be absent as there is no tab-header. However, there will be an Add users button at the bottom of the Users tab.

Back to Data Feeds Introduction

Back to User and Feed Management Introduction

Need more help?

Ask the Reckon Community at: https://community.reckon.com/

Or Log a Support Ticket: https://www.reckon.com/au/support/