Senor Omni Directional Scanner – Change the Scanner Setting

Legacy KB ID: 4985

Question

How do I configure the Senor Omni Directional Scanner for POS?

Answer

Please use the following barcodes to set your scanner for POS:

1.    Scan the “Enter/Exit Programming Mode” barcode, there will be 2 beeps (low-high) indicating ready to make settings.

2.    Scan barcodes for the desired feature (1 beep)

 Step 2 - Header: 

Step 3 - Tilde

Step 4 - Set

Step 5 – Message  Terminator

3.    Scan the “Enter/Exit Programming Mode” barcode again to save the configuration, there will be 2 beeps (long---short) indicating settings successfully.

After reading a valid barcode in programming mode the scanner will give a high beep.